Printech Archive
Re: Use of acetone in reformulated products

New Message Reply About this list Date view Thread view Subject view Author view

From: John Henry (
Date: Tue May 25 1999 - 07:49:21 CDT

Mark Stoddard is on the money with his comments regarding the role of the
EPA in regulation. It is true that special handling is required to properly
and safely use acetone in the workplace, but that should be the concern of
the manufacturer/printer who chooses to use it. The individual firm must
determine the usage procedures in line with the suggestions in the MSDS
sheet and proper workplace safety concerns.

Environmental impact of the use of chemicals and materials is the concern of
the EPA.

John G. Henry

-----Original Message-----
Sent: Monday, May 24, 1999 5:13 PM
Subject: Re: Use of acetone in reformulated products

Do you believe EPA should assume the roles of OSHA, the Fire Marshal, and
DOT to regulate chemicals based on flammability and combustibility?

If yes, what value would or could EPA add to help a company safely manage
their flammable and combustible materials?

If no, EPA must review material usage based on waste generation [or its
potential] and the impact of that waste generation on the environment.

We live in an imperfect world with imperfect standards. There are no
chemicals [with the possible exception of water] that are absolutely benign
under all circumstances. Rules and regulations allow for alternatives
[chemicals, processes] to be discovered and used and for lawyers and
consultants to profit.

So, why regulate a substance as a VOC when the impacts to ozone [smog]
generation is considered negligible because the potential for a fire or
explosion is high? It seems like it should be up to OSHA, the Fire Marshal
or DOT to do so.

Mark C. Stoddard
Compliance & Technical Assistance Program

>>> <> 05/24/99 10:37AM >>>

You are absolutely correct in describing the EPA position on the delisting
of acetone and other chemicals. However, the response completely misses the
point that Marci raised. With its high vapor pressure and low ignition point
the use of acetone in an industrial environment becomes quite hazardous.

Shouldn't the EPA be concerned about such hazards as they contemplate
removing such materials from the basic control system provided by the VOC
regulations? Apparently there is no one in the EPA who will admit to having
such a responsibility. I've asked around with no success.

Alex Ross

New Message Reply About this list Date view Thread view Subject view Author view
Disclaimer / Copyright Info
Email the PNEAC Webmaster